Metal cutting and processing

Correct preparation of steel components for fabrication, installation, repair or replacement.

Send dimensioned drawings or sketches, material, thicknesses, quantities and finish requirements. Special tolerances and inspections should be stated explicitly.

Plasma cutting and contour preparation; Drilling and connection-detail preparation; Component adjustment and fit-up; Preparation for welding, installation or repair. The final scope is defined after reviewing the project and site conditions.

Documentation: We clarify geometry, material, thickness and required tolerances. Marking: We establish references and operation sequence. Processing: We cut, drill and adjust components within the confirmed scope. Verification: We check dimensions and readiness for the next stage.

Photographs support an initial assessment but do not replace dimensions, quantities, materials and access conditions. Price, schedule, transport and included work are defined in the quotation for the specific project.

Request documents applicable to the quoted configuration: drawings, materials, inspections and, where required by the project, test reports or certificates. A photograph or commercial name alone does not demonstrate a protection rating or certified performance.